Current Issue : April-June Volume : 2022 Issue Number : 2 Articles : 5 Articles
We fabricated CaCO3-coated vesicles as drug carriers that release their cargo under a weakly acidic condition. We designed and synthesized a peptide lipid containing the Val-His-Val-Glu-Val-Ser sequence as the hydrophilic part, and with two palmitoyl groups at the N-terminal as the anchor groups of the lipid bilayer membrane. Vesicles embedded with the peptide lipids were prepared. The CaCO3 coating of the vesicle surface was performed by the mineralization induced by the embedded peptide lipid. The peptide lipid produced the mineral source, CO3 2, for CaCO3 mineralization through the hydrolysis of urea. We investigated the structure of the obtained CaCO3-coated vesicles using transmission electron microscopy (TEM). The vesicles retained the spherical shapes, even in vacuo. Furthermore, the vesicles had inner spaces that acted as the drug cargo, as observed by the TEM tomographic analysis. The thickness of the CaCO3 shell was estimated as ca. 20 nm. CaCO3-coated vesicles containing hydrophobic or hydrophilic drugs were prepared, and the drug release properties were examined under various pH conditions. The mineralized CaCO3 shell of the vesicle surface was dissolved under a weakly acidic condition, pH 6.0, such as in the neighborhood of cancer tissues. The degradation of the CaCO3 shell induced an effective release of the drugs. Such behavior suggests potential of the CaCO3-coated vesicles as carriers for cancer therapies....
Co-processing is commonly used approach to improve functional characteristics of pharmaceutical excipients to become suitable for tablet production by direct compression. This study aimed to improve tableting characteristics of lactose monohydrate (LMH) by co-processing by fluid-bed melt granulation with addition of hydrophilic (PEG 4000 and poloxamer 188) and lipophilic (glyceryl palmitostearate) meltable binders. In addition to binding purpose, hydrophilic and lipophilic excipients were added to achieve self-lubricating properties of mixture. Co-processed mixtures exhibit superior flow properties compared to pure LMH and comparable or better flowability relative to commercial excipient Ludipress®. Compaction of mixtures co-processed with 20% PEG 4000 and 20% poloxamer 188 resulted in tablets with acceptable tensile strength (>2 MPa) and good lubricating properties (ejection and detachment stress values below 5 MPa) in a wide range of compression pressures. While the best lubricating properties were observed when glyceryl palmitostearate was used as meltable binder, obtained tablets failed to fulfil required mechanical characteristics. Although addition of meltable binder improves interparticle bonding, disintegration time was not prolonged compared to commercial excipient Ludipress®. Co-processed mixtures containing 20% of either PEG 4000 or poloxamer 188 showed superior tabletability and lubricant properties relative to LMH and Ludipress® and can be good candidates for tablet production by direct compression....
Introduction. In drug delivery, solid dosage forms, of which tablet is the commonest, are still the leading preferences. An area of research focus in tablet drug delivery is the search for tablet excipients. $is study was aimed at evaluating and optimizing native Taro Boloso-I starch as a tablet disintegrant. Methods. $e response surface method with central composite design (CCD-RSM) was used for the analysis and optimization of the concentration of native Taro Boloso-I starch and compression force. Wet granulation method was used for the preparation of paracetamol tablets. $e response variables considered were tablet crushing strength, friability, and disintegration time. Results and Discussion. Both the native Taro Boloso-I starch concentration and compression force had increasing effect on the tablet breaking force. $e friability of the tablets was shown to decrease with increasing levels of the disintegrant concentration. On the other hand, compression force had a decreasing effect on friability in the investigated range. $e disintegration time of the tablets was found to decrease with the concentration of the starch. $e paracetamol tablets prepared with the optimized levels of native Taro Boloso-I starch and compression force showed tablet breaking force of 116.24 N, friability of 0.153%, disintegration time of 1.36 min, disintegration efficiency ratio of 562.3 N/(%Min), and comparative disintegration efficiency ratio of 13.6 with respect to commercial potato starch. Conclusions. $etablets exhibited improved crushing strength, friability, in vitro disintegration time, and disintegration efficiency ratio which suggest the novel applicability of the native Taro Boloso-I starch as an efficient pharmaceutical tablet disintegrant....
The formulation of an ideal vaginal drug delivery system (DDS), with the requisite properties, with respect to safety, efficacy, patient compliance, aesthetics, harmonization with the regulatory requirements, and cost, requires a meticulous selection of the active ingredients and the excipients used. Novel excipients defined by diversity and multifunctionality are used in order to ameliorate drug delivery attributes. Synthetic and natural polymers are broadly used in pharmaceutical vaginal formulations (solid, semi-solid dosage forms, implantable devices, and nanomedicines) with a promising perspective in improving stability and compatibility issues when administered topically or systemically. Moreover, the use of biopolymers is aiming towards formulating novel bioactive, biocompatible, and biodegradable DDSs with a controllable drug release rate. Overviewing vaginal microenvironment, which is described by variable and perplexed features, a perceptive choice of excipients is essential. This review summarizes the recent advances on the excipients used in modified vaginal drug delivery formulations, in an attempt to aid the formulation scientist in selecting the optimal excipients for the preparation of vaginal products....
Polymeric materials from plants continue to be of interest to pharmaceutical scientists as potential binders in immediate release tablets due to availability, sustainability, and constant supply to feed local pharmaceutical industries. Paracetamol tablet formulations were utilized in investigating the potential binding characteristics of pectin harnessed from various okra genotypes (PC1-PC5) in Ghana. The pectin yields from the different genotypes ranged from 6.12 to 18.84%w/w. The pH of extracted pectin ranged from 6.39 to 6.92, and it had good swelling indices and a low moisture content. Pectin extracted from all genotypes were evaluated as binders (10, 15, and 20%w/v) and compared to tragacanth BP. All formulated tablets (F1-F18) passed the weight uniformity, drug content, hardness, and friability tests. Based on their crushing strength, tablets prepared with pectin from the various genotypes were relatively harder (P ≤ 0:05) than tablets prepared with tragacanth BP. Tablets prepared with pectins as binders at 10%w/v and 15%w/v passed the disintegration and dissolution tests with the exception of PC4 at 15%w/v. Incorporation of pectin from all genotypes (excluding PC5) as a binder at concentrations above 15%w/v (F13, F16, F14, and F15) produced tablets which failed the disintegration test and showed poor dissolution profiles. Thus, pectin from these genotypes can be industrially commodified as binders in immediate release tablets using varying concentrations....
Loading....